Manual Temperature
Control (MTC)
1. Temperature Control
Rotate this control to regulate the temperature of the air inside the passenger compartment. Rotating the dial to the left into the blue area of the scale indicates cooler temperatures, while rotating to the right into the red area indicates warmer temperatures.
2. Blower Control
Rotate this control to regulate the amount of air forced through the ventilation system in any mode. The blower speed increases as you move the control to the right from the “0” (OFF) position. There are four blower speeds.
3. Recirculation Control
Rotate this control to change the system between recirculation mode and outside air mode. Recirculation can be used when outside conditions such as smoke, odors, dust, or high humidity are present.
NOTE:
• Continuous use of the Recirculation mode may make the inside air stuffy
and window fogging may occur.
Extended use of this mode is not recommended.
• The use of the Recirculation mode in cold or damp weather could cause windows
to fog on the inside, because of moisture buildup inside the vehicle. Select the
outside air position for maximum defogging.
• Recirculation can be used in all modes except for Defrost and Mix.
• The A/C can be deselected manually without disturbing the mode control selection.
4. Mode Control
Rotate this control to change the system between Modes (Panel, Bi-Level, Floor, Mix, Defrost).
• Panel
Air is directed through the outlets in the instrument panel. These outlets can be adjusted to direct airflow.
NOTE: The center instrument panel outlets can be aimed so that they are directed
toward the rear seat passengers for maximum airflow to the rear.
• Bi-Level
Air is directed through the panel and floor outlets.
• Floor
Air is directed through the floor outlets with a small amount flowing through the defrost and side window demister outlets.
• Mix
Air is directed through the floor, defrost, and side window demister outlets. This setting works best in cold or snowy conditions that require extra heat to the windshield. This setting is good for maintaining comfort while reducing moisture on the windshield.
• Defrost
Air is directed through the windshield and side window demister outlets. Use this mode with maximum blower and temperature settings for best windshield and side window defrosting.
NOTE: The air conditioning compressor operates in Mix or Defrost, even if the
Air Conditioning (A/C) button is not pressed. This dehumidifies the air to help
dry the windshield. To improve fuel economy, use these modes only when necessary.
5. A/C Button
Press this button to engage the Air Conditioning. A light will illuminate when the Air Conditioning system is engaged.
MAX A/C
For maximum cooling, use the A/C and recirculation modes at the same time.
ECONOMY MODE
If economy mode is desired, press the A/C button to turn OFF the indicator light and the A/C compressor. Then, move the temperature control to the desired temperature.
See also:
(E) After Driving
Pull over to a safe location. Refer to “Whenever You Stop to Use TIREFIT” before
continuing.
1. Turn the Mode Select Knob (5) to the Air Mode position.
2. Uncoil the power plug and insert the plug ...
At the filling station
Make sure that the left-hand sliding side door is completely closed before
refueling. You could damage the door and the sliding lock system which comes into
play when the fuel flap is open.
Y ...
Jump starting
If the battery is flat, you can use another battery to start the engine. Its
capacity must be the same or slightly greater than the flat battery.
Proceed as follows fig. 1:
1) Connect positive ter ...