How to use the gears

Press the clutch fully before shifting the gear stick into one of the positions shown in the diagram in fig. 2 (the diagram is also on the gear lever knob).

IMPORTANT

Only engage the reverse gear when the vehicle is completely stationary. With the engine running, wait for at least 2 seconds with the clutch pedal pressed to avoid damaging the gears and scratching.

To engage reverse (R) from neutral:

– shift the lever to the right and back.

For version 1.4 8V and 1.6 16V, to engage reverse (R) from neutral, raise collar A-fig. 3 set under the knob and move the lever rightwards and then backwards at the same time.

You must press the clutch fully down to change gear properly. It is therefore

You must press the clutch fully down to change gear properly. It is therefore essential that there is nothing under the pedals. Make sure that mats are lying flat and do not get in the way of pedals.

    See also:

    Rear seats (where provided)
    According to versions, two or three head restraints can be provided. To remove the head restraints, first remove the rear parcel shelf (see paragraph “Extending the boot”), press button (A) set ...

    To Close
    With the sunroof in the full open position, pull the power sunroof button and hold it for approximately one second, the sunroof will return to the vented position. Pull the switch a second time an ...

    Main beams
    The warning light on the dial turns on when the main beams are turned on. ...