Adjusting the front seat belt height

Always adjust the height of the seat belt to fit the person wearing it. This Make the height adjustment when the vehicle is stationary.

Always adjust the height of the seat belt to fit the person wearing it. This could greatly reduce the risk of injury in the case of collision.

The belt is adjusted properly when the webbing passes approximately halfway between the edge of the shoulder and the neck. Four height adjustments are possible.

To raise the belt: raise loop A-fig.

8 to the required position.

To lower the belt: press knob B, and at the same time move loop A to the required position.

Check that the seat belt is locked in position by pushing down on loop A without pressing knob B.

After you have made the adjustment, always make sure that the loop is attached

firmly in one of the fixed positions and cannot move. To do this, with the button After you have made the adjustment, always make sure that the loop is attached firmly in one of the fixed positions and cannot move. To do this, with the button released, exert a further pressure to allow the anchoring device to catch if release did not take place at one of the preset positions.

    See also:

    Battery
    The battery is of the “Limited maintenance” type: under normal conditions of use the electrolyte does not need topping up with distilled water. CHECKING THE CHARGE fig. 22 The battery charge may b ...

    To Resume Speed
    To resume a previously set speed, push the RES (+) button and release. Resume can be used at any speed above 20 mph (32 km/h). ...

    Rear double doors
    The double rear doors are fitted with a catch which stops the opening at an angle of approximately 90°. The catch system is designed to ensure the best comfort in use. An accidental knock or gus ...