Proceed as follows:
❒ Ensure that the handbrake is up;
❒ Put the gear lever into neutral;
❒ Turn the ignition key to MAR. The warning lights
and
will light up on the instrument panel;
❒ Wait for the warning lights and
to go out. The hotter the engine is,
the quicker this will happen;
❒ Press the clutch pedal down to the floor without touching the accelerator;
❒ Turn the ignition key to AVV as soon as warning light
goes out. If you wait too long you
will lose the benefit of the work done by the glow plugs. Release the key as soon
as the engine starts.
If the engine does not start at the first attempt, return the ignition key to STOP before repeating starting.
If, when the ignition key is on MAR, warning light remains lit, turn the key to STOP and then back to MAR; if the warning light remains on, try with the other keys provided with the car.
If you still cannot start the engine, contact Fiat Dealership.
IMPORTANT Never leave the ignition key at MAR when the engine is off.
The warning light will flash for 60 seconds at start-up or during prolonged cranking to signal a fault in the glow plug heating system. You can use the car as usual if the engine starts but you should contact a Fiat Dealership as soon as possible.
See also:
Brakes
SERVICE AND EMERGENCY BRAKES
Front:
– disc, floating shoe, self-ventilated.
Rear:
– drum, self-centering calipers.
Crossed hydraulic circuit control.
Vacuum brake booster.
ABS system with four ...
Main beam headlights
To change the halogen bulb, proceed as follows:
1) Remove the protection cover Cfig.
18 turning it counterclockwise;
2) Release clip A-fig. 19, remove connector B and remove the bulb C.
...
23. Anti-Lock Brake (ABS) Light
This light monitors the Anti-Lock Brake System (ABS). The light will turn on
when the ignition switch is turned to the ON/RUN position and may stay on for as
long as four seconds.
If the ABS li ...