Proceed as follows:
❒ hold the bonnet up with one hand and, with the other, remove rod (C) from recess
(D) replace it in its clip;
❒ lower the bonnet at approx. 20 cm from the engine compartment and then let it
drop, ensuring that it is fully closed and not just held in position by the safety
catch. If the bonnet does not close properly do not push it down but open it again
and repeat the above procedure.
IMPORTANT Always check that the bonnet is closed properly to avoid its opening while the car is travelling.
WARNING
For safety reasons the bonnet shall always be perfectly closed when travelling. Always check for proper bonnet locking. If the bonnet is left inadvertently open, stop the car immediately and close the bonnet.
WARNING
The bonnet might fall violently if the support rod is not positioned properly.
WARNING
Perform the above operations when the car is stationary.
See also:
How to warm up the engine after is has just started (petrol and diesel
versions)
– Begin to move forward slowly letting the engine turn at medium revs.
Do not accelerate abruptly.
– Do not push the engine to its limit for the first few kilometers. You are recommended
to wait u ...
General information
Turning on of warning light is accompanied by specific message and/or by buzzer
sound where provided by instrument panel. These indications are concise and cautionary
and shall not be considered a ...
Engine
GENERAL FEATURES
(*) For specific markets where applicable
FUEL SUPPLY/IGNITION
Petrol versions
Electronic Multipoint sequential phased injection integrated with ignition,
return less
syst ...