1. Remove the plastic cap from the back of the headlamp housing.
2. Rotate the bulb counter-clockwise.
3. Remove the bulb and replace as needed.
4. Install the bulb and rotate clockwise to lock in place.
5. Reinstall the plastic cap.
See also:
Electronic control units
When the vehicle is being used normally, special measures are not necessary.
The following instructions must be followed very carefully, however, if you work
on the electrical system or in cases wh ...
Handbrake on
Turning the ignition key to MAR the warning light on the dial turns on, but it
should go off after few seconds. The warning light turns on when the handbrake is
on.
IMPORTANT If the warning lig ...
Key-In-Ignition Reminder
Opening the driver’s door when the key is in the ignition and the ignition switch
position is OFF/LOCK, sounds a signal to remove the key. ...