If Your Engine Overheats

In any of the following situations, you can reduce the potential for overheating by taking the appropriate action.

• On the highways — slow down.
• In city traffic — while stopped, place the transmission in NEUTRAL, but do not increase engine idle speed.

NOTE: There are steps that you can take to slow down an impending overheat condition:

• If your air conditioner (A/C) is on, turn it off. The A/C system adds heat to the engine cooling system and turning the A/C off can help remove this heat.
• You can also turn the temperature control to maximum heat, the mode control to floor and the blower control to high. This allows the heater core to act as a supplement to the radiator and aids in removing heat from the engine cooling system.

Driving with a hot cooling system could damage your vehicle. If the pointer CAUTION!

Driving with a hot cooling system could damage your vehicle. If the pointer rises to the H (red) mark, the instrument cluster will sound a chime. When safe, pull over and stop the vehicle with the engine at idle. Turn off the air conditioning and wait until the pointer drops back into the normal range. If the pointer remains on the H (red) mark for more than a minute, turn the engine off immediately and call for service.

You or others can be badly burned by hot engine coolant (antifreeze) or steam WARNING!

You or others can be badly burned by hot engine coolant (antifreeze) or steam from your radiator. If you see or hear steam coming from under the hood, do not open the hood until the radiator has had time to cool. Never try to open a cooling system pressure cap when the radiator or coolant bottle is hot.

    See also:

    “Smart washing” function
    Pulling the stalk towards the steering wheel (unstable position) operates the windscreen washer; indeed, the latter comes into action automatically if the stalk is pulled for more than half a se ...

    To increase the memorised speed
    The speed memorised can be increased in two ways: ❒ pressing the accelerator and then memorising the new speed reached; or ❒ momentaneously turning the ring (B) to (+). Each pulse of ...

    Dipped beams
    To change the halogen bulb, proceed as follows: 1) Remove the protection cover Bfig. 18 turning it counterclockwise; 2) Release clip A-fig. 20, remove connector B and remove the bulb C. ...