Use only compact chains, or other traction aids that meet SAE type “Class S” specifications. Chains must be the proper size for the vehicle, as recommended by the chain manufacturer.
NOTE: Do not use tire chains on a compact spare tire.
CAUTION!
To avoid damage to your vehicle or tires, observe the following precautions:
• Use Security Chain Company (SCC) SCC Z6 low profile or equivalent chains on 185/55R15
tires only.
• Because of restricted chain clearance between tires and other suspension components,
it is important that only chains in good condition are used. Broken chains can cause
serious damage. Stop the vehicle immediately if noise occurs that could indicate
chain breakage. Remove the damaged parts of the chain before further use.
• Do not exceed 45 mph (70 km/h).
• Drive cautiously and avoid severe turns and large bumps, especially with a loaded
vehicle.
• Install chains on the front wheels as tightly as possible and then retighten after
driving about 0.5 mile (0.8 km).
• Do not drive for prolonged periods of time on dry pavement.
• Observe the tire chain manufacturer’s instructions on the method of installation,
operating speed, and conditions for use. Always use the lower suggested operating
speed of the chain manufacturer, if different from the speed recommended by the
vehicle manufacturer.
Always use the lower suggested operating speed if the chain manufacturer and vehicle manufacturer suggest different maximum speeds. This notice applies to all chain traction devices, including link and cable (radial) chains.
See also:
Roof rack/ski rack
FASTENERS
3-door versions
Move the seal aside in the points shown in the figure to reach the fasteners.
The rear fasteners are in the areas indicated by the printed
reference mark O on the rear ...
Heating
Proceed as follows:
❒ rotate knob (A) (pointer on -) completely to the right;
❒ turn knob (C) to the required speed;
❒ move knob (D) to:
to warm the feet and at the same time ...
Follow Me Home/Headlight Delay
When this feature is selected the driver can choose to have the headlights remain
on for a preset period of time.
Activation
Remove the key or turn the ignition to the OFF/LOCK position, and pull ...