1. Press the AUTO button on the Automatic Temperature Control (ATC) Panel, the
indicator will illuminate when on.
2. Next, adjust the temperature you would like the system to maintain by adjusting
the temperature control buttons. Once the desired temperature is displayed, the
system will achieve and automatically maintain that comfort level.
3. When the system is set up for your comfort level, it is not necessary to change
the settings. You will experience the greatest efficiency by simply allowing the
system to function automatically.
NOTE:
• It is not necessary to move the temperature settings for cold or hot
vehicles. The system automatically adjusts the temperature, mode and fan speed to
provide comfort as quickly as possible.
• The temperature can be displayed in U.S. or Metric units by selecting the US/M
customer-programmable feature. Refer to the “Electronic Vehicle Information Center
(EVIC) — Customer-Programmable Features” in this section of the manual.
To provide you with maximum comfort in the Automatic mode during cold start-ups, the blower fan will remain on low until the engine warms up. The blower will increase in speed and transition into AUTO mode.
See also:
Traction Grades
The Traction grades, from highest to lowest, are AA, A, B, and C. These grades
represent the tire’s ability to stop on wet pavement, as measured under controlled
conditions on specified government ...
Magnetic card/ticket slots
The slots for holding magnetic cards and tickets (phone card, toll slips, etc.)
can be found on the central tunnel unit.
WARNING
Do not travel with the glove compartment open: risk of passenger ...
Fuel consumption
The fuel consumption figures given in the table below are determined on the basis
of the homologation tests set down by specific European Directives.
The procedures below are followed for measuring ...