20. Brake Warning Light

This light monitors various brake functions, including brake fluid level and

This light monitors various brake functions, including brake fluid level and parking brake application. If the Brake Warning Light turns on it may indicate that the parking brake is applied, that the brake fluid level is low, or that there is a problem with the brake system reservoir.

The light will remain on until the cause is corrected.

If brake failure is indicated, immediate repair is necessary.

Driving a vehicle with the red brake light on is dangerous. You could have WARNING!

Driving a vehicle with the red brake light on is dangerous. You could have a collision. Have the vehicle checked immediately.

Vehicles equipped with the Anti-Lock Brake System (ABS), are also equipped with Electronic Brake Force Distribution (EBD). In the event of an EBD failure, the Brake Warning Light will turn on along with the ABS Light. Immediate repair to the ABS system is required.

Operation of the Brake Warning Light can be checked by turning the ignition switch from the OFF/LOCK position to the ON/RUN position. The light should illuminate for approximately two seconds. The light should then turn off unless the parking brake is applied or a brake fault is detected. If the light does not illuminate, have the light inspected by an authorized dealer.

The light also will turn on when the parking brake is applied with the ignition switch in the ON/RUN position.

the degree of brake application. NOTE: This light shows only that the parking brake is applied. It does not show the degree of brake application.

    See also:

    Ceiling lights
    With toggling lens To replace a bulb: 1) Remove the ceiling light fig. 35 by releasing the clipped on lens frame in the point shown by the arrow. 2) Open the container A-fig. 36 and replace the b ...

    Right-hand stalk
    Windscreen wiper/washer fig. 84 The device will only work when the ignition key is at MAR. POSITIONS fig. 84 0 - windscreen wiper off; 1 - flick wipe; in some versions, four selections are possi ...

    To Lock The Doors And Liftgate
    Press and release the LOCK button on the RKE transmitter to lock all doors and the liftgate. The turn signal lights will flash and the horn will chirp to acknowledge the signal. If a door is ajar ...