The driver seat also has a memory feature, which can operate in two ways:
Memory Function Option 1) — Full Seat Back And Track Fore/Aft Position Memory: After using the EZ entry function, the
After using the EZ entry function, the seatback angle and the Track fore/aft adjuster can both re-lock into the position they were most recently adjusted to. This is accomplished if the seat is moved fully rearward to its last fore/aft position on the tracks before the seat back is returned upright.
Memory Function Option 2) — Seat Back Only Memory:
After using the EZ entry function, the seat back may first be returned upright prior to going back to the last fore/aft (memory) position on the tracks. This results in the seat back memory being set only – The track will then be locked forward of its last set fore/aft memory position.
To then reset the fore/aft track memory feature (to reestablish memory function option 1), the seat has to be returned fully rearward to its last fore/aft memory track position as described in Memory function option 1).
See also:
Cylinder replacement procedure
To replace the cylinder proceed as follows fig. 16h:
– disconnect connection A; turn counter-clockwise the cylinder to replace and
raise it; fit the new cylinder and turn it clockwise; connect conn ...
Engine starting
The car is fitted with an electronic engine lock device. If the engine fails
to start, see paragraph “Fiat Code system” in section “Dashboard and controls”. ...
ASR - wheel antiskid system
Messages are displayed (on certain versions) when the ASR function is activated/deactivated
manually (see “ASR system” in the “Dashboard and controls” section).
ASR system switching off is indicate ...